The unit will enter an "off state" once the return temperature reaches the required set value and the pump shuts down automatically. 3.3. Troubleshooting and Maintenance
The "Plus" series interface is known for its simplicity.
| Parameter | Value | |-----------|-------| | Temperature range | +20°C … +140°C (standard) / +160°C (optional) | | Heating capacity | 9 kW (3 x 3 kW stainless steel immersion heaters) | | Cooling type | Direct injection (water-to-water) | | Cooling water requirement | 10–40°C, 2–6 bar, flow rate ≥ 40 L/min | | Pump type | Centrifugal, stainless steel impeller | | Max. pump pressure | 4.8 bar at 0 L/min; 2.5 bar at 60 L/min | | Flow measurement | Turbine wheel sensor (4–20 mA output) | | Tank volume | 3.6 liters (stainless steel, insulated) | | Electrical supply | 400V ±10%, 3-phase, 50/60 Hz, 16 A (CEE plug) | | Control system | Wittmann R8.2 controller with 5.7” color touchscreen |
Utilize the cool down stop or cool safety temp functions within the Fn key menu. This allows the unit to cool down safely, which is crucial for protecting the heater and preventing overtemperature conditions. Wittmann Tempro Plus D 360 Manual
Touch-screen microprocessor interface (Tempro Plus D) featuring integrated data logging and interface protocols (EUROMAP 82.1, OPC UA, SPI). 2. Installation and Initial Setup
Ensure all water hoses (supply, return, mold inlet, mold outlet) are secured and leak-free. Power Supply:
Wittmann frequently releases firmware updates. Ensure the manual version you are reading corresponds to the serial number on your unit’s backplate. The unit will enter an "off state" once
The D 360 features a built-in level probe. If water drops below minimum, the controller closes the heater, opens the fill valve, and displays “Refill water – check leakage.”
This article serves as a guide to understanding the key aspects of the Tempro Plus D 360, focusing on operation, maintenance, and technical capabilities often found in the official user manual. 1. Introduction to the Wittmann Tempro Plus D 360
Check for closed valves in the mold circuit; inspect pump impeller for debris. | Parameter | Value | |-----------|-------| | Temperature
Self-optimizing control, automatic filling with leakage monitoring, and advanced safety features. 2. Key Components and Specifications (Manual Highlights)
Confirm the electrical supply matches the unit's voltage requirements. The Tempro Plus D 360