V2000-c Rfid Access Control User Manual Official

All programming is performed using the keypad. Follow these steps to access system settings:

If the Master Code is lost, reset the device manually using the hardware pins. Power off the V2000-C unit completely.

The tamper sensor on the back of the unit is exposed to light or not flush against the wall. V2000-c Rfid Access Control User Manual

By following this comprehensive guide, administrators can ensure that their V2000-C RFID access control system is installed, configured, and operated correctly, providing a high level of security and access control.

Sets the authentication method to require BOTH a valid card AND a valid PIN code for entry. All programming is performed using the keypad

A: Please follow the Initialization Procedure in Part IV. This will restore the password to 12345 .

If you need specific wiring diagrams, reset instructions, or advanced features (like anti-passback or time schedules), please provide the exact or brand label from your device. The tamper sensor on the back of the

The connector is a dry contact relay for the lock. You can set its normal state using the J1 jumper.