Place the laminator on a flat, stable, and heat-resistant work surface. Ensure there is at least 6 inches of clear space behind the machine so the laminated document can exit freely without bending or jamming. Step 2: Powering On and Selecting Mil Setting
The Staples 17466 is compatible with most standard thermal laminating pouches in 3‑mil or 5‑mil thickness. Staples‑branded pouches are a natural match, but quality pouches from other manufacturers generally work well as long as the correct temperature setting is used.
Turn off the machine, unplug it, and let it cool completely for 30 minutes. staples 17466 laminator manual
Do not attempt to laminate empty pouches, standard paper with heat-sensitive ink (like thermal receipts), or excessively thick items (like cardboard or coins).
Once the document fully exits the rear slot, remove it immediately. Place the laminator on a flat, stable, and
Turn off the power switch immediately. Firmly press down on the Jam Release Lever (ABS lever) located on the back of the machine. While holding the lever down, gently pull the document backward out of the front entry slot. Lamination Appears Cloudy or Has Milky Patches
Operating the Staples 17466 requires minimal setup. Follow these steps for a perfect, bubble-free lamination every time. Step 1: Preparation Staples‑branded pouches are a natural match, but quality
Once the "Ready" light is on, feed the sealed edge of the pouch into the entry slot. Never feed the open edge first, as this will cause a jam.
Insert the pouch into the front entry slot of the laminator.
However, even the best office equipment requires proper operation and maintenance to avoid jams and ensure high-quality results. This guide serves as a comprehensive , covering setup, usage, maintenance, and troubleshooting. 1. Getting Started: Staples 17466 Setup and Features
: Let the machine pull the pouch through completely. Avoid pulling it out manually. Allow the document to cool on a flat surface before trimming. Troubleshooting & Maintenance : If a pouch gets stuck, use the jam release lever