Attach the transmitter rod between the ball joint on the tiller arm and the ball joint on the RF300 lever.
For the most accurate readings, the center of the RF300 should be aligned as closely as possible with the center of the rudder post. The transmission arm features two slots to accommodate the linkage. When the rudder is centered (amidships), the arm should be positioned so the linkage is perpendicular to the centerline of the boat.
The RF300 connects to your Simrad system via .
Move the steering from port to starboard to ensure the transmission link does not hit any components or pass "over dead center," which could block the system. 2. Electrical Wiring simrad rf300 installation manual
Proper installation ensures long-term reliability and prevents common "Rudder Feedback Failure" errors. B&G RF300 Rudder Feedback Unit | Autopilot - Simrad
Once wired, you must "teach" the system the rudder's physical limits. Enter Installation Menu: On your control unit (like an ) or MFD, navigate to Settings > Autopilot > Installation Select Source: Ensure the rudder source is set to
The is a critical component for many Simrad autopilot systems, providing precise, real-time data on the rudder's position. This feedback ensures smooth steering performance and protects your steering gear by allowing the autopilot computer to know exactly where the rudder is at all times. Attach the transmitter rod between the ball joint
Check: Inspect the mechanical ball joints for slack, play, or looseness. Even 1mm of physical play can cause the pilot to over-correct continuously.
involves precise mechanical alignment and a simple two-wire electrical connection to your autopilot computer. This unit is specifically designed for boats with inboard engines to provide high-resolution rudder position data. Mechanical Installation
Solid, comprehensive guide held back by a few technical leaps When the rudder is centered (amidships), the arm
: Connect the two wires to the dedicated "Rudder Feedback" terminals on your Simrad junction box (e.g., J300X, AC10, AC20, or AC42). Brown Wire
The Simrad RF300 Installation Manual provides comprehensive guidelines for the proper installation of the radar system. Following these guidelines ensures not only optimal performance but also safety for the users and those on board the vessel. It's crucial for installers to be familiar with the manual and to follow each step carefully to avoid any issues or hazards.
An accurately calibrated autopilot depends entirely on precise data from your rudder feedback unit. The Simrad RF300 Rudder Feedback Unit is a robust, high-resolution sensor that transmits the exact angle of your rudder to your Simrad autopilot computer.
: Drill and tap the rudder tiller arm so the distance from the rudder post center to the ball joint (Y1) is equal to the distance from the
