| 错误代码 / 报错信息 | 可能原因分析 | 解决方案 | | :--- | :--- | :--- | | | 配置文件 MP.ini 的校验和 (Checksum) 被工具修改 | 在 MPALL 主界面右上方找到并点击 No Mapping 按钮，点击一次改变其状态后再执行量产。 | | “CT-ISP fail! 0x1102” / “Program burner error 0x1106” | Burner 固件不匹配；闪存颗粒特殊 | 更换不同的 MPALL 版本（如从 5.03.0A 尝试 5.13.0C 或 3.63.0D）；若无效，考虑尝试使用 ST-TOOL。 | | “Mode 255 Flash Status Error” | U盘彻底进入保护模式/固件分区表完全损坏 | 使用 Mode 3 低格一遍；或拆开 U盘，短接闪存特定引脚强制复位。 | | 量产工具完全不识别 U盘 | 工具版本太旧；驱动冲突；USB 端口问题 | 更换最新工具；运行 GetInfo 查看；更换 USB 2.0 端口；排除杀毒软件拦截。 | | “Incorrect IDBLK version” | IDBLK_TIMING.dll 版本与固件不兼容 | 在 MP.ini 中指定 IDBLK Version ，或更换版本。 |
If the drive works but is extremely slow after repair, you likely used an outdated firmware version or a "Sorting" tool like UPTool, which prioritizes stability over speed.
Sometimes the MPTOOL cannot detect the drive because the firmware is completely dead. The controller is in "ROM Mode." You need to short two pins on the physical chip.
: An alternative scanner that pulls detailed diagnostic strings, specifying the precise controller revision and the exact make/model of the internal NAND memory (e.g., Toshiba, Hynix, or SanDisk TLC). Is MPTool the Right Choice vs. UPTool? phison ps225107ps2307 mptool
[PenDriveMP] IC Type=2251-07 [Parameter] Mode=3 Format=1 [Firmware] Specified=1 BinPath=C:\MPALL\ Burner Erase=1 Use code with caution.
RAW / Unformatted Error: Windows asks to format the drive but throws an error when attempting it.
drive. The tool should display a device, though it might show "???" or "F2-Error". The controller is in "ROM Mode
Understanding the hardware is critical before attempting low-level software repairs.
Look for your drive to populate inside one of the numbered boxes. If it displays a green text overlay, it is ready for processing.
Once detected, the tool will reveal a mapped box corresponding to your USB channel. A soft pink or yellow color indicates readiness. Click . UPTool
The primary function of this tool is to restore drives that are unrecognized, "no media," or write-protected by flashing them with compatible firmware (BN and FW files) . Key Features and Capabilities
Download and unzip the MPALL distribution (e.g., version MPALL v3.72.0B or later) and run MPALL_F1_9000.exe as an administrator.
Before flashing any files, you must gather the precise hardware profile of your USB drive. Using the wrong firmware version can permanently brick the controller. 1. Run Phison GetInfo
Click the Setting button. If prompted, select "New Setting" and "Basic Adjustment". Controller & Interface: Controller: Select PS2251-07 .