This scenario simulates connecting a primary office building to a remote warehouse located 2 kilometers away. The local devices use copper, but the long-distance link must use fiber. Step 1: Deploy the Network Devices Open Cisco Packet Tracer.
Typically features one RJ45 Ethernet port for copper connections and one SFP/Fiber port for optical connections. Setup: Place the Media Converter in the workspace.
: Acts as a "translator" between electrical signals (copper) and light pulses (fiber).
One of the most common points of confusion for students is looking for a dedicated "Media Converter" device in the Packet Tracer toolbox.
Go to > Switches and drag a 2960 Switch or a 3650 Multilayer Switch onto the workspace. media converter in cisco packet tracer link
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
Fiber modules often run at fixed speeds. If your copper side is Gigabit (1000 Mbps) and your fiber side is FastEthernet (100 Mbps), the link will fail. Ensure both sides match or configure manual speeds using the speed command in the CLI.
At its core, a media converter is a cost-effective and flexible device used to connect two different types of network media, such as converting a . This capability is critical for extending network reach beyond the 100-meter limitation of standard copper cabling, as fiber optics allow for data transmission over distances measured in kilometers.
Choose the model. Place it in the center of your workspace. Label it Media-Converter . This scenario simulates connecting a primary office building
The first packet might time out due to ARP resolution, but the subsequent packets will return successful replies.
Select the Fiber cable (orange dashed line). Connect the SFP/Fiber port of your switch to another fiber-enabled device (like a Server or another Switch with a fiber module). Key Scenarios for Using Media Conversion
If you try to drag a copper cable from a 2960 switch to an SFP port on a 3560 switch, Packet Tracer will refuse the connection. You need a translator.
If everything is configured correctly, you should see successful ping results. Typically features one RJ45 Ethernet port for copper
Note: Some devices are "Fixed Configuration," while others are "Modular." You need a device with an slot. 2. Add the Fiber Module (SFP) Click on the Switch to open its configuration window. Go to the Physical tab.
"Cannot connect [FastEthernet0] to [GigabitEthernet0] – Incompatible media types."
Now you will bridge the long distance between the two switches using fiber cabling, successfully completing the media-converted path. Go back to the menu.
In most physical networks, a media converter looks like a small metal box. In Packet Tracer, you will not find this box.