Lenel Lnl-3300-m5 Installation Manual Upd

Connect the opposite end to a managed network switch with direct routing capabilities to the host OnGuard server. Configuration and Jumper Settings

The LNL‑3300‑M5 features two dedicated inputs – one for enclosure tamper monitoring (TMPR) and one for UPS fault monitoring (PFLT). These inputs can be wired to:

: Set DIP switches to 1:OFF, 2:ON, 3:OFF, 4:OFF to use default communication parameters for the initial setup .

Are you migrating from a (like a PXNplus), or are you looking for the DIP switch configuration for a fresh install? LNL 3300 M 5 | PDF | Electrostatic Discharge - Scribd Lenel Lnl-3300-m5 Installation Manual UPD

The LNL-3300-M5 is engineered with the exact footprint and mounting hole pattern of the legacy Micro/5 CPU board.

Use this checklist from the updated manual:

Configure I/O modules (such as the LNL‑1320‑2RP or LNL‑1320‑S2RP) using the onboard DIP switches to set the device address and communication baud rate. Always refer to the specific module's documentation for correct DIP switch settings. Connect the opposite end to a managed network

Sets physical address if using serial communication overrides Configuration Mode Turn ON to force the card into default configuration mode Firmware Update Enables secure firmware flashing mode Login Security Resets administrative credentials when toggled during boot System Mode Standard operational mode Network Configuration (Web Interface) Turn on power to the LNL-3300-M5 board.

A common source of "tamper" faults on the M5 is incorrect resistor placement. The updated manual states:

The LNL-3300-M5 uses DIP switches for hardware-level addressing and configuration. Are you migrating from a (like a PXNplus),

Visual indicators for power, heartbeat, network activity, and communication faults.

Before you begin the installation process, ensure that you have:

Pro tip: Search document number .