Ivoclar Programat P100 Manual English ((exclusive)) Jun 2026

Modifying program parameters requires using the dedicated function keys located below the display screen:

Start the calibration program. The furnace will heat up to the theoretical melting point of silver (961.8°C).

Provides critical warnings, such as ensuring the local voltage matches the furnace rating before connection to prevent damage.

Always disconnect power before maintenance or troubleshooting. 3. Installation and Setup Proper installation ensures the best results. ivoclar programat p100 manual english

Never touch the outer shroud of the heating chamber or the lower insulation platform during or immediately after a cycle. Temperatures can cause severe burns.

Regular maintenance extends the lifespan of your P100 and ensures consistent firing results.

: Never open the furnace head by hand; use the electronic controls to avoid damaging the lift mechanism. Energy Efficiency Never touch the outer shroud of the heating

Disclaimer: This article provides a summary of information found in publicly available operating documentation and should not replace the official, in-depth manual provided by Ivoclar Vivadent. If you can tell me: is displaying Whether this is a new installation or a used unit

Shows actual and setpoint values for temperature and vacuum.

Place the furnace on a level, stable surface, away from direct sunlight, vibrations, and excessive heat sources. Place the furnace on a level

The Ivoclar Programat P100 remains a workhorse in many dental laboratories due to its reliable microprocessor control and fully automatic vacuum system. However, keeping this classic furnace running at peak performance requires regular attention to calibration and maintenance. Key Features of the Programat P100

The firing chamber reaches very high temperatures ( ). Use proper safety tools to handle the firing tray.

Are you looking to (e.g., porcelain-fused-to-metal, low-fusing glass)?

: Note that factory-default "empty" programs have no name and cannot be run until parameters are set.

Before starting the furnace, proper installation is essential for longevity and precision.