Icom Ci V Usb Interface Schematic Top !link! -

This is the minimalist's dream. The schematic often uses two general-purpose NPN transistors, such as or 2N3904 , along with a few resistors and diodes. It works by using one transistor to drive the bus when transmitting, and another to buffer the received data. This circuit is simple, low-cost, and effective for a single radio. However, it may not have the current sinking capability to drive a bus with multiple devices.

: Install any necessary drivers on your computer. FTDI provides drivers that allow the USB interface to appear as a virtual COM port.

: The interface is typically powered directly from the computer's 5V USB bus , eliminating the need for an external power supply.

Most DIY designs use two optocouplers (typically 6N137 or PC900 for speed, or 4N35 for lower baud rates) to decouple the radio ground from the computer ground. icom ci v usb interface schematic top

Set the (default 0x5E for IC-7000, 0x76 for IC-7300, etc.) in your software (e.g., WSJT-X, FLRig, HRD).

The Icom Computer Interface Five (CI-V) protocol allows you to control your transceiver using a computer. It enables computer-aided tuning (CAT), logging, and digital mode operation.

Ensure your software (e.g., HRD) uses the correct hex address (e.g., 94h for IC-7300, 4Eh for IC-706). This is the minimalist's dream

Keep the cable length between the interface and the radio as short as possible. 3. Drivers and Software Configuration

For decades, Icom’s protocol has been the backbone of computer control for Icom transceivers. Whether you own an IC-7300, IC-9700, IC-705, or a legacy unit like the IC-706, the ability to link your radio to logging, digital mode, and remote control software transforms your operating experience.

Snap a small onto the cable near the radio connector. Construction and Testing Steps Step 1: Assembly This circuit is simple, low-cost, and effective for

Do you plan to build this from , or would you prefer guidance on using a pre-made USB-to-TTL module ?

Building your own Icom CI-V (Communications Interface 5) USB interface is a popular DIY project for amateur radio operators. It allows you to control transceivers—from older models like the IC-735 to modern rigs—via a computer using a single 3.5mm mono cable. Understanding the CI-V Bus

Icom CI-V USB Interface Schematic: Top DIY and Commercial Solutions

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

While a direct, non-isolated connection will work, it risks creating ground loops. Ground loops introduce AC hum, digital switching noise into your audio path, and—in worst-case scenarios—allow Stray RF to damage your computer or transceiver. Optocouplers physically separate the computer's electrical ground from the radio's electrical ground using light signals. 3. The Top CI-V USB Interface Schematics