Hxc-fw-installer.hex

The .hex file is specific to ARTERY-based Gotek drives. If you have an STM32-based Gotek, you will instead need the .dfu version of the installer. For such support requests, the developer recommends contacting them directly by email. You should have received all the needed information, including the correct file, via email after your firmware registration.

The Gotek is now flashed with the HxC bootloader and is ready to load the full HxC firmware from a USB stick. Post-Installation: Activating HxC Firmware

if your programmer provides its own power. Connect GND, SWDIO, and SWCLK only, and power the HxC via its dedicated power input.

Select the hxc-fw-installer.hex file in the "Download to device" section. Click or Program to begin the flashing process. 3. Finalizing the Installation Once finished, disconnect the USB cable. Remove the jumper from BOOT0 . Hxc-fw-installer.hex

The installation procedure varies slightly based on your Gotek's processor (STM32 vs. AT32). However, the general process for using hxc_fw_installer.hex follows these steps: 1. Preparation

This specific installer file programs the microcontroller on an emulator board. It replaces factory code with the custom HxC operating framework, allowing the hardware to read modern storage media and mimic legacy floppy signals perfectly. Supported Hardware Ecosystem

Use a jumper or wire to connect BOOT0 to the 3.3V pin nearby (or the JP2 jumper if available). Connect the Gotek to your PC using the USB A-to-A cable. 2. Flashing hxc-fw-installer.hex Open or STM32 Dfuse. Select the USB DFU port to detect the Gotek. You should have received all the needed information,

Get the latest HxCFEUSB_V3_X_X_Xa.UPD file.

Installing this file allows your Gotek drive to support diverse disk formats (3", 3.5", 5.25", 8") and various emulation modes, such as Indexed and Direct mode, directly from a FAT32 USB stick. Why Use HxC Firmware?

After the installer finishes writing the operational firmware, the HxC will reboot. You should see: Connect GND, SWDIO, and SWCLK only, and power

According to the official manual, "the whole process take some minutes". Be patient and do not disconnect anything until you see the "Done!" message.

Comprehensive Guide to What is Hxc-fw-installer.hex?

Once the bootloader is installed via the .hex file, users gain access to enhanced features: Flash a Gotek with a USB A to USB A cable - HxC2001

Once the bootloader is installed, subsequent firmware updates (using .upd files) can be done for free via a USB stick. Usage Instructions Format a USB stick to FAT32 .