Manual: Hormann A445

Verify that all terminal screws are tight. Vibration from large industrial motors can slowly loosen screw-clamp terminals over time. Check the cycle counter in the programming menu to determine if structural components (like counter-balance springs) are approaching their rated life expectancy.

Safety Note: Only qualified personnel should install or maintain this industrial control unit. Always shut down power before handling.

The A445 is an "A/B" series control unit (A445/B445) known for its ease of use and versatility. It generally features a three-button interface (open, stop, close) on the cover, making it easy for personnel to operate the industrial door without needing an external wall switch. hormann a445 manual

External push buttons, key switches, or pull cords connect to the low-voltage terminal strip:

The motor ran longer than its programmed maximum time without reaching a limit switch. Verify that all terminal screws are tight

: Features a user-friendly 2-digit or 4-digit display (depending on variant) for easy programming and error message reading. Integrated Controls

: Check the wicket door contact or ensure all X31 sockets are properly assigned. JustAnswer Safety & Maintenance Emergency Release Safety Note: Only qualified personnel should install or

To ensure maximum safety and compliance, always refer to the official documentation. You can often find the (in English or other languages) by searching for "Hormann A445 manual PDF" on authorized service websites like AvtomatikaVorot or Remootio .

The closing edge safety device (crush sensor) detected an obstacle or is faulty.

| LED Blink Pattern | Meaning | Solution (from manual) | | --- | --- | --- | | 1 blink, pause | Travel limit not set | Program open/close limits (see Part 5). | | 2 blinks | Force exceeded (obstruction) | Check door balance. Remove obstruction. Re-learn force. | | 3 blinks | Photo eye error | Clean lenses. Align sensors. Check wiring. | | 4 blinks | Motor temperature too high | Wait 20 minutes for cooling. Improve ventilation. | | 5 blinks | Internal logic board fault | Cycle power. If persists, replace control PCB. | | Continuous fast blink | Radio interference | Change remote channel or move large metal objects away. |

Ensure low-voltage control cables (sensors) are routed separately from high-voltage power lines to prevent interference.