When you finish, turn off the hot air switch. Do not unplug the station immediately. The pump will continue running to blow cool air through the wand until the element drops below 100°C. This protects the heating element from burning out. Using the Soldering Iron
This screw anchors the internal diaphragm air pump during transit. Leaving it in place causes severe vibration, extreme noise, and permanent pump damage upon powering up. Station Placement Place the unit on a flat, heat-resistant workbench. Ensure the rear ventilation slots are unobstructed.
Ensure the side and rear ventilation slots are completely unobstructed.
Adjust numerical values for temperature and airflow. gordak 952 user manual updated
Unscrew the large, brightly colored shipping screw from the center of the chassis.
Apply a small bead of fresh solder to your external thermometer probe, then press the soldering iron tip firmly onto the sensor. Read the temperature display on your external meter.
The diaphragm air pump is suspended on rubber mounts inside the chassis to minimize vibration. For shipping safety, it is locked down. Turn the station upside down. When you finish, turn off the hot air switch
Flashes to indicate the heating element is actively maintaining temperature. 2. Soldering Iron Section
Flip the unit over and completely remove the transport screws using a screwdriver before plugging it in.
feature intelligent PID temperature control, dual LED digital displays, and microcomputer-driven safety functions. Hot Air Gun Soldering Iron Power Consumption 270W – 650W 50W – 60W Temperature Range 100°C – 500°C 200°C – 480°C Airflow Capacity 0.3 – 120 L/min (Max) Pump Type Diaphragm Pump 2. Setup and Controls This protects the heating element from burning out
Set the to your desired thermal target.
Place the iron tip onto an external thermocouple thermometer probe. Allow the reading to stabilize for two minutes. If the external thermometer reads higher or lower than 350∘C350 raised to the composed with power C
Like many diaphragm-pump-based hot air stations, the Gordak 952 is shipped with shipping secure screws located on the underside of the chassis. These red or silver screws hold the pump stable during transit.
, use a small flat-head screwdriver to slowly turn the "CAL" potentiometer slot on the front panel until the external thermometer matches the dial setting. Cleaning and Care
Plug the unit into a grounded outlet (110V for US/CA, 220V for EU/ASIA – verify your model). Do not use a non-grounded extension cord.