Open the hood and verify that the scrap filters, pump suction filter, and overflow tube are correctly seated in the wash tank. Close the hood. Turn on the main water supply valve.
Connect the automatic dosing pumps to your commercial cleaning chemicals. Only use high-temperature, low-suds, liquid detergents. 2. Operation and Usage Fagor FI-80 Go to product viewer dialog for this item.
Once you have your manual, following its step-by-step instructions will make setup and operation easy.
He patted the front of the dishwasher. "Good girl," he whispered. The Fi80 sat silent and clean, ready for the next load.
| Section | Content | |---------|---------| | | Water supply connection (3/4" threaded hose), drain hose height (min 50 cm, max 110 cm), leveling feet adjustment, electrical connection (220-240V, 50Hz, 10A fuse). | | Control Panel | Explanation of program selector dial, start/pause button, half-load button (if equipped), and indicator lights (salt, rinse aid, end of cycle). | | Programs | Typical cycles: Intensive (70°C), Normal (65°C), Eco (50°C), Rapid (30-40°C), Glass/Soak. | | Water Softener | How to set the softener level (based on local water hardness: H1 to H5) and refill dishwasher salt. | | Filters & Maintenance | Cleaning the triple filter system (coarse, fine, microfilter) and spray arms. | | Error Codes | E1 (water inlet issue), E2 (drain problem), E4 (flood protection active). | fagor fi80 dishwasher manual
Wipe down the inside of the chamber and check the door gasket for food buildup or tears. Leave the door slightly ajar overnight to air dry and prevent odors. Weekly Maintenance
Always turn off the main electrical disconnect switch before performing any interior maintenance, descaling, or component inspection.
208-240V, 60Hz, 1-phase or 3-phase (convertible). Water Inlet: 3/4" Imperial hose connector.
Defective heating element; faulty thermostat; incoming water too cold. Open the hood and verify that the scrap
The longevity of your Fagor FI80 depends on regular maintenance. The manual suggests the following schedule:
The machine takes approximately 20 minutes to reach the required 185°F rinse temperature
| Specification | Detail | | :--- | :--- | | | For plates up to Ø 42 cm | | Wash Tank Capacity | 45 litres | | Wash Temp / Rinse Temp | 60°C / 90°C | | Rinse Water Consumption | 3 litres | | Heating Elements | 4.5 kW (wash tank); 9 kW (boiler) | | Electrical Connection | 400 V - 3+N+E | | Drain Hose Compatibility | FI-64, FI80, ECO120, FI100, MF120 |
Ensure the overflow tube, filter, and scrap baskets are correctly positioned. Fill & Warm Up: Connect the automatic dosing pumps to your commercial
Allow more time between cycles for the booster to heat. If temperatures never rise, contact a technician to test elements and thermostats.
Check if overflow tube is seated correctly; Clean pressure switch tube. Blocked wash arms; Low water temperature.
Requires a minimum of 140°F (60°C) for optimal heating cycles.