: Send logs to your network management system for monitoring.
: A specialized command to reveal "hidden" or advanced debugging commands.
GET AL
Ericsson MINI-LINK commands follow a strict structure. Understanding this logic is more important than memorizing specific commands.
GET ETH
DCN (management network) bring‑up
| Command | Description | |---------|-------------| | show version | System hardware/software version | | show running-config | Current active configuration | | show startup-config | Saved configuration | | write memory / copy running-config startup-config | Save config | | show system | System uptime, temperature, voltage | | reboot | Restart the unit | ericsson mini link cli commands
The Ericsson MINI-LINK (including the Traffic Node and 6000 series) uses a Command Line Interface (CLI) primarily for deep troubleshooting, advanced configuration, and automated scripting. Getting Started
Deactivates all active diagnostic loopbacks. Always run this after troubleshooting to restore customer traffic. 7. Configuration Management and Backups : Send logs to your network management system for monitoring
Mastering the Ericsson MINI-LINK CLI transforms you from a GUI-dependent operator into an efficient, scriptable network engineer. Whether you are commissioning a new hop, troubleshooting fading, or automating backups across 100 sites, the commands covered here—from show radio performance to script apply —will give you granular control over your microwave transport network.
: Checks the current temperature of each board and identifies any threshold exceedances. Understanding this logic is more important than memorizing