Configuring the DVB01 is done through its two-level menu system. The four physical buttons are: [SET] , [SWI] , [+] , and [-] . Remember that a , and a "long press" is more than one second . All your settings are automatically saved and are not lost when the power is turned off .
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
Apply stable operating power to and V- . The LED will light up and display the active voltage reading at VIN.
Short-press the SET button. The screen will flash. dvb01 user manual
I can then provide specific for your scenario. Share public link
: The central terminal connected directly to your external load supply line.
The module features three tactile buttons located beneath the digital display: , SWI (Switch/Increment), and NUM (Number selection/Decrement). Step 1: Selecting the Function Mode (F-1 to F-5) Configuring the DVB01 is done through its two-level
All setting parameters are automatically saved, even when power is removed.
: Keeping a device powered only when a power grid stays within safe operational boundaries.
The relay pulls in (closes NO) when the measured voltage is between the Lower Limit (V2) and the Upper Limit (V1). If the voltage goes above V1 or below V2, the relay releases. All your settings are automatically saved and are
Disconnects from the load when the relay is triggered. 3. Key Functions & Modes
Here’s a basic outline of a setup to protect a 12V battery from over-discharge: